
Replacing a laser cutting machine goes wrong most often at the end, not the beginning. Shops spend months evaluating the new machine and about ten minutes thinking about the old one, and then the...

Replacing a laser cutting machine goes wrong most often at the end, not the beginning. Shops spend months evaluating the new machine and about ten minutes thinking about the old one, and then the...

Sizing a laser chiller starts with the machine builder’s cooling requirement and then accounts for everything that requirement assumes. The source has a specified heat load, but the chiller also has to handle the...

A new laser operator should learn the machine before they learn the part. The instinct in a busy shop is to get someone producing on day two, so training starts with loading a program...

Getting laser machine part numbers right starts with the machine, not the part. Pull the serial number and the exact model designation off the data plate first, because the same model name can cover...

A fiber laser losing power is almost never a dying laser source, and the shops that assume it is end up spending on the most expensive component in the machine to fix something that...

When buying a fiber laser cutting machine, compare machines on the things that decide how they will run in your shop for years, not just the headline numbers on the spec sheet. That means...

The new vs used laser cutting machine decision comes down to four things: how soon you need the machine running, what technology your work actually requires, how much you can verify about a used...

The right laser chiller coolant is whatever the laser manufacturer specifies for your machine, and for most fiber and CO2 cutting machines that means distilled or deionized water, sometimes with a specific corrosion inhibitor...

A small shop should automate laser cutting when the laser is sitting idle while people load sheets, pull parts, and sort skeletons, and when there is enough steady work to keep an automated cell...

A good laser cutter daily checklist covers five areas before the first program runs: safety systems, the cutting head and optics, assist gas, cooling, and the table and motion system. Once an operator has...
Looking to update your current system with a more productive New Tanaka Fiber Laser? Reach out to us at [email protected]. Check out the New advancements Tanaka Lasers machines have to offer.
No products in the cart.
No products in the cart.